WPW10190961 Whirlpool (5-Cube) Ice Maker AP6016625




WPW10190961 Whirlpool Ice Maker (5-Cube) Assembly

Used For 20cf – 23cf Models with Ice Bucket in Freezer Door.
When replacing you will have to re-use the bottom mounting tray.
Replaces Part Numbers: W10190961, AP6016625, PS11749917, AH11749917, EAP11749917, 2212352, W10122503, 2212353, AP4360427, PS2341898, EAP2341898.

This ice maker is controlled by an ‘optic lED sensor’ that scans the level of ice in the ice container.
When the ice level in the container blocks the led beam (Full of Ice) it (shuts off the ice maker).
When the ice level in the container is below the led beam (Low of Ice) it (turns on the ice maker).
Be sure to correctly diagnose before purchasing.
Here are the 4 things to check!
1) (Freezer temp. approx. 0? to 5?)
2) (ice level optics board)
3) (water inlet valve)
4) (ice maker).

Installation Instructions

  • Turn off the power supply to the ice maker by pushing the switch (located on the wall just below the ice maker) to the off position.
  • Carefully remove the ice maker cover door by pushing the left bracket to the left from the top.
  • To remove the wire cover, remove the one screw from the upper right rear of ice maker area.
  • Then slide out your ice maker as you hold in the locking tab on the left side of the mounting bracket area.
  • Remove the ice maker by unplugging the unit on the right and place on a table or workbench.
  • Then flip the ice maker to remove the screws that hold the bottom mounting tray.
  • Now use the same screws to fit the new ice maker to the mounting tray (bracket) and follow the above steps in reverse order to install new ice maker.
  • Now simply switch on the ice maker and wait for some ice.

The WPW10190961 Ice Maker is found for the following models.



Whirlpool Parts

Buy in stock Whirlpool Parts to repair your appliance with fast shipping. Free email tech support. Wholesale prices on all replacement Whirlpool Parts.


Additional information

Weight 4 lbs