KitchenAid WPW10190965 8-Cube Bare Ice Maker
Used for many replacements of 8-cube modular style ice makers.
Uses The Front Cover, Wiring Harness, Wire Arm and Mounting Bracket off your Old Ice Maker!
1) Replacing the cover requires a simple pull on the cover to pop it off the old ice maker and then simply push it on to the new ice maker.
2) Replacing the wire harness you simply depress the plastic tab where it plugs into the side of the ice maker and simply push the harness into the new ice maker.
3) The wire shut-off arm pulls out of the front of the ice maker and also pulls out of the rear water fill cup on the rear of the ice maker and pushes into their respective spots on the new ice maker.
Replaces Part Numbers: W10190965, AP6016628, PS11749920, AH11749920, EAP11749920, 1471727, 626633, 626661, 626662, WPW10277450, AH2341899, AP4360346, EAP2341899, PS2341899, W10122506, W10122507, W10122510, W10190966, W10190969.
Used to repair the following Symptoms:
Ice maker not making ice.
Ice maker dispenses too little ice.
Ice maker dispenses too much ice.
Ice maker leaking water.
- First, remove the three mounting screws that attach the ice maker to the freezer wall.
- Disconnect the wire plug from the old ice maker at the freezer wall & take old ice maker out & lay on a table or workbench.
- You will need to transfer the Ice Maker Cover, Wire shut-off arm, Mounting bracket and Electrical wire harness from your old ice maker to this new unit.
- Next is to Install the new unit by plugging in the wire harness and re installing the 3 mounting screws.
- Now it?s all done and ready to freeze. Enjoy.